Hello,
I've created a repository in my database using spoon. All works fine.
However I am trying to run a command line kettle script as below:
./kitchen.sh /user:"PDI_REPOSITORY" /pass:"entahox" /rep:"MarcosAWSDW1" /dir:"/" /job:"TEST_TEMP_JOB"
This runs fine but if I want to run this using a different repository for test the command line arguments except the job parameter are ignored and the job runs on the default repository. Also, if I enter an invalid user id or password on the command line the job continues to run successfully. It's almost as though these command parameters are never used and kitchen.sh only uses the job parameter.
What am I doing wrong? Help!
Any guidance is much appreciated,
John Byrne
I've created a repository in my database using spoon. All works fine.
However I am trying to run a command line kettle script as below:
./kitchen.sh /user:"PDI_REPOSITORY" /pass:"entahox" /rep:"MarcosAWSDW1" /dir:"/" /job:"TEST_TEMP_JOB"
This runs fine but if I want to run this using a different repository for test the command line arguments except the job parameter are ignored and the job runs on the default repository. Also, if I enter an invalid user id or password on the command line the job continues to run successfully. It's almost as though these command parameters are never used and kitchen.sh only uses the job parameter.
What am I doing wrong? Help!
Any guidance is much appreciated,
John Byrne